7/27/2023 0 Comments Free cnc single line fontsI assume it has to do with the way my paths are defined, but I can’t figure it out. My hope was that this would be sufficient for the font to work in my CAD application, but there is still something I’m not doing correctly. I see that there has already been some discussion of this topic on a couple of threads here, but I think I’ve come a bit further and I’m hoping for a little help in figuring out the final problems I’m having creating my own fonts the way that does it.Īs I understand (from those other forum threads), if I export my fonts from Glyphs as TTF with “remove overlap” and “autohint” turned off, Glyphs will export without closing the open paths that I have created. There are a number of options on in TTF that are designed to be used this way. Of course I’m very aware that creating a font in this way is not supported in OTF/TTF, which requires closed paths! However, a number of CAD and other software tools still use special TTF fonts designed in this way, ignoring the “correct” way of interpreting the font. no closed paths – such that these paths can be used by a CNC or engraving tool, with the line width set by the cutting tool itself. I have designed a typeface using only single strokes – ie.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |